
Cut out rigid foam, restore timbers, get your mortgage moving again
Closed Cell Spray Foam Removal in Taunton
Closed Cell Spray Foam Removal in Taunton is what we do when rigid foam has trapped moisture, blocked a mortgage or left your loft colder than it should be. British Spray Foam Co covers Taunton, Somerset and the surrounding villages, cutting out closed cell foam, cleaning the timbers and leaving the roof space ready for a proper breathable insulation system. Same-day surveys are available across Taunton.
What's included
What Our Closed Cell Foam Removal Service Includes
Every removal job includes the survey, the cutting and extraction, the timber check and the documentation pack. Reinsulation is optional and priced separately, so you only pay for what you actually want done.
Full Pre-Work Survey
We measure the foam coverage, check timber moisture with a moisture meter, and take thermal imaging camera readings. You get a written fixed price and a clear explanation of what has to come out and why. No cutting starts until you approve it.
Controlled Foam Extraction
Closed cell foam is cut into blocks with a reciprocating saw and oscillating multi-tool, then lifted out by hand and bagged. An industrial vacuum extractor and dust extraction unit run throughout. Dry ice blasting handles any foam bonded tight to the timber.
Timber Inspection and Treatment
Every exposed rafter, batten and joist is checked for rot and treated where needed. Soft or failed sections are replaced. This is the part lenders care about most, and it is included in the price rather than added on afterwards.
Photo and Moisture Report
You receive dated photographs of the exposed structure, before-and-after moisture readings, and a written summary of the removal. Surveyors and mortgage lenders accept this pack. It is the document that gets stalled sales moving again.
Waste Removal and Clean-Up
All foam, dust and debris is bagged and removed from site. We vacuum the loft, wipe down surfaces and leave the space ready for whatever comes next. You should not have to clean up after us.
Service overview
What Closed Cell Spray Foam Removal in Taunton Involves
Closed Cell Spray Foam Removal in Taunton is the controlled cutting, extraction and disposal of cured polyurethane foam from roof timbers, rafters and loft decks. Closed cell foam sets rock-hard, so we slice it into manageable blocks with a reciprocating saw and an oscillating multi-tool, then lift it out without tearing the timber underneath. An industrial vacuum extractor and dust extraction unit run throughout, and we finish with a moisture meter and thermal imaging camera check so you can see exactly what condition the roof space is in.
Most Taunton homeowners call us because a mortgage lender has refused to lend on a spray-foam-insulated property, or because damp and condensation has started showing on ceilings in older Victorian and 1930s homes around the town. Closed cell foam insulation removal in Taunton Somerset is also booked when roof timber rot is suspected, or when the foam has been installed over a failing vapour barrier. We survey first, tell you what has to come out, and give you a fixed price before any cutting starts.
The service timeline
How Our Closed Cell Foam Removal Process Works
The process flexes to the condition, but these checkpoints keep decisions clear.
Survey and Quote
We visit, measure the foam coverage, check the timbers with a moisture meter and thermal imaging camera, and photograph everything. You get a fixed written price the same day, usually within two hours of the survey. No cutting starts until you have approved it.
Protect the Property
We lay dust sheets, seal doorways and set up an air scrubber and dust extraction unit so foam dust and debris stay in the work area. PPE respirators go on before any cutting. On occupied homes around Galmington and Comeytrowe we work room by room so you keep access to the rest of the house.
Cut and Extract Foam
Closed cell foam comes out in blocks, not sheets. We use a reciprocating saw and oscillating multi-tool to cut it into sections, then lift them out by hand and bag them. A typical 40 square metre loft takes one to two days. Dry ice blasting is used on the final pass where foam is bonded tight to the timber.
Clean and Inspect Timbers
Once the bulk is out, we clean residual foam from the rafters, check every timber for rot, and treat or replace anything that has failed. You get a full photo record of the exposed structure, which is exactly what mortgage lenders and surveyors ask for.
Reinsulate and Hand Back
If you want the loft reinsulated, we fit a vapour barrier and rebuild with mineral wool, Kingspan boards or open cell spray foam, depending on the roof construction. We clear all waste, vacuum the area, and walk you through the finished job before we leave.
Tools & methods
Tools and Methods We Use for Foam Removal
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Reciprocating saw
Cuts cured closed cell foam into manageable blocks without tearing the timber underneath. The blade choice matters, and we swap between wood and foam blades as the cut moves along the rafter.
Oscillating multi-tool
Gets into corners, around nails and between closely spaced rafters where a full saw will not fit. It is the tool that stops us damaging timber we are trying to save.
Industrial vacuum extractor
Lifts loose foam fragments, dust and debris as we cut. Running it continuously keeps the loft clear and stops dust migrating into the rest of the house.
Dry ice blasting machine
Removes the last traces of foam bonded tight to timber without abrading the wood surface. No blasting media left behind, which matters when the roof space has to be reinsulated straight afterwards.
Thermal imaging camera
Shows cold spots, hidden damp and areas where foam has been applied unevenly. We use it before removal to plan the work, and after to confirm the roof space is drying correctly.
Moisture meter
Gives a numeric reading of timber moisture content before and after removal. Those readings go into the documentation pack that lenders and surveyors ask for.
Air scrubber and dust extraction unit
Filters airborne dust for the duration of the job. Essential on occupied homes, and standard on every removal we carry out across Taunton.
Use cases
When to Book Closed Cell Foam Removal in Taunton
These examples show how the service framework adapts rather than forcing every call through one repair.

Damp Ceiling Fixed in Taunton Town Centre
A Victorian terrace near Taunton Town Centre had damp patches spreading across an upstairs ceiling. Closed cell foam on the rafters was trapping water from a slow roof leak, and the timber moisture reading was well above safe levels. → We cut out the foam, dried the roof space, and replaced a failed section of vapour barrier. Moisture readings dropped from high to normal within three weeks, and the ceiling was redecorated with no sign of the damp returning.
Loft Conversion Cleared in Comeytrowe
A homeowner in Comeytrowe was planning a loft conversion but the existing closed cell foam blocked the rafters and floor area. The builder would not start until the foam was gone and the timbers had been inspected. → We cleared 26 square metres of foam in a single day, inspected and treated the timbers, and left the space ready for the builder. The conversion started on schedule the following Monday with no delays.
Problems we solve
Problems Closed Cell Foam Removal in Taunton Solves
Rigid foam causes a small set of expensive problems, and they all get worse the longer the foam stays in place. Here is what we fix and how.
Mortgage lender refuses to lend on a spray-foam-insulated property
We remove the closed cell foam, inspect and photograph the timbers, and supply a moisture report your lender can act on. Most Taunton sellers we work with get their sale back on track within two weeks of the removal being completed.
Damp and condensation from trapped moisture
We cut out the foam, let the roof space dry, and check every timber with a moisture meter. If the vapour barrier has failed, we replace it. Reinsulating with mineral wool or open cell spray foam keeps the loft warm without sealing moisture in.
Roof timber rot spreading along the rafters
We expose the timbers during removal, treat any early rot, and replace sections that have gone soft. Catching it during a foam removal is far cheaper than a roof repair later. We show you photos of every affected area.
Foam performing worse than the insulation it replaced
We strip the foam back and rebuild the insulation properly, using Kingspan boards, Rockwool or open cell spray foam depending on the roof construction. The loft ends up warmer, drier and compliant with current standards.
Pricing process
Closed Cell Spray Foam Removal Costs in Taunton
900 - 2,400 pounds for most Taunton lofts; commercial and large roofs priced on survey
Foam coverage area
Price scales with square metres. A small attic under 20 square metres sits at the lower end, while a full roof at 60 square metres or more moves towards the top of the range. We measure during the survey.
Bond strength to timber
Foam sprayed directly onto bare rafters comes away more easily than foam applied over old insulation or a failed vapour barrier. Bonded foam needs dry ice blasting on the final pass, which adds time.
Access and working height
A loft with a proper hatch and boarded floor is quick to work in. Restricted hatches, low headroom and steep roof pitches slow the job down. We assess access during the survey and price accordingly.
How much does closed cell spray foam removal cost in Taunton?
Most Taunton lofts cost between 900 and 2,400 pounds to clear, with larger roofs or commercial units running higher. Price depends on the square metres of foam, how hard it is bonded to the timber, access, and whether you want reinsulation afterwards. We give a fixed written price after a free survey, so you know the number before any cutting starts.
Who does closed cell foam insulation removal in Taunton Somerset?
British Spray Foam Co handles closed cell foam insulation removal in Taunton Somerset, covering the town and villages from Norton Fitzwarren to Trull. We have been removing spray foam since 2021 and hold City & Guilds insulation qualifications, CHAS accreditation and TrustMark registration. Call 0182 329 7064 and we will book a survey, usually within 48 hours.
Can closed cell spray foam removal be done same day in Taunton?
Same-day removal is possible on small lofts, typically under 20 square metres, if you call before midday and the foam is accessible. Most jobs are booked within two to five days because we schedule a survey first. For urgent mortgage deadlines, tell us the date and we will do everything we can to fit you in.
Is closed cell foam removal covered by insurance in Taunton?
It depends on your policy. Some insurers cover removal when the foam was installed by a previous owner and has caused damp or timber damage, while others treat it as an improvement issue. We provide a written report with photos and moisture readings that you can send to your insurer. Check your buildings cover before booking and we will supply whatever documentation they ask for.
Ready when you are
Book Closed Cell Spray Foam Removal in Taunton Today
Call British Spray Foam Co on 0182 329 7064 for a free survey and a fixed price. We are CHAS accredited, TrustMark registered and have been removing spray foam across Somerset since 2021. Same-day surveys available where the diary allows.

Talk with the local team
Request Closed Cell Spray Foam Removal
Ring 0182 329 7064 between 8am and 6pm Monday to Friday and you will get a real person who can book a survey on the spot. Out of hours, the emergency line stays open for storm damage and leaks. Email works too, and we reply the same working day.


